Petty Tribute
I aged some 15″X8″ Wheel Vintiques wheels to look Rusty, and mounted 245/60-15 Goodrich TAs on the rear. I still need to do the same for the fronts.
I repaired the old steering wheel, primed and painted to match the interior.
I tried three different shifter handles and all hit the seat, dash, or both. I finally made a 6″ adaptor to raise a pistol grip shifter 6″, which was enough to clear the bench seat and stay under the boot.
I bought all of the pipes needed to get the block hugger collectors to 2.5″ side exiting exhaust. This is all that is required to finish the car. These are the pipes needed to do the right side.
Magnum GT
If you’ve been following along on the Magnum GT, You’ll know it was recently treated to a new poly-urethene paint job, and the leather dyed before that. This week, everything was taken out of the trunk, the Surface flash removed, it was then masked, primed and painted. Since the car is pure black, it was an easy rattle can project. I’ll give the a paint a week to get hard, and then clean and replace the carpet.
The Screamin’ Woody
The engine was reassembled with a new crank, rod, and set of lifters; and stabbed into the car. It will be started and tuned next week.
Outfitting the Stacker
I spent a day getting the Stacker trailer mostly outfitted. On the door I installed a door cabinet fire bottle holder, tire gauge holder, rack of screw drivers and a pair of clamps that hold the weather station in travel mode, and the telescopic pole it goes on (to raise 5′ over the stacker’s roof) when in the pits. Another set of clamps were installed inside the door to hold the pole in travel mode.
On the front wall of the trailer, I mounted a stainless coat rack with 4 stainless steel hangers for my safety suits. Above the coat rack I mounted a pair of stainless steel baskets for racing shoes and gloves. On the ceiling I mounted a swiveling hook to hold my helmet.
Next to the overhead cabinets I mounted an Oil Rack and used Industrial Grey Velcro to hold the lift’s remote control in place. To the rear of the trailer is a strap holder, jack pouch, a blower holder and a couple cord holders.
I also put the hand tools in the appropriate drawers, but I’ll need to go back to clean and oil them before the first race.
In the attic I mounted a holder for four 5gallon fuel jugs.
I still have a day left to finish organizing myself into a 2′ shorter trailer.
Other
- Installed an electric gate
- Replaced all bulbs in Magnum XE with LED
- Replaced AC blower motor on Magnum XE
- Removed the Grill to the Magnum GT to paint when it gets warmer
- Figured out I had the wrong parts to install an overdrive in the Magnum XE, and ordered the correct ones
- Did a little cleaning and organizing in the shop
